Commercial EL 10 Steam Room Door

The Eurolite design series can be custom cut to any size. We can help design your steam room enclosure, have the door and panels manufactured and shipped direct to your home or jobsite. The standard glass thickness is 3/8" and works for all commercial and residential enclosures.

The watertight system provides full steam containment! This keeps the unwanted moisture out of the adjoining space. The hardware finishes are: Chrome, Brushed Nickle and Matte black.

Precise finished (tile to tile) opening measurements are required for ordering these steammer doors. A shop drawing will be produced from the manufacturer. Custom sizes will require the customer's signature before the glass manufacturing can begin. This process ensures a watertight fit for the door and panels.

The hinges mount to 1" wide metal strip. This strip mounts to the tiled/slate jamb and must anchor into the wood or steel framing for adequate support. There are low profile (1/4" h outside, 3/4" h inside x 1" wide)  aluminum strikes/strips for the stops. Both have clear polycarbonate bulb seal gaskets built in. See image below for detail. The top of the door has a flexible clear sweep and the bottom has a hooded double sweep that deflects moisture into the steam room as the drips/condensation run down the glass.

If need to fill a 96" high opening, use a fixed transom to enclose the top 12". There is a 1/8” space left around the fixed glass transom (mounted with clips) that will be sealed with silcon. The contact between the top of the door and fixed panel with be filled with an adhesive T sweep or bulbe seal (both are supplied).

This price reflects the standard finished tile to tile door opening size of 34" x 82".  These doors can not increase in height or width as this is the weight maximum for the hinges.

Note: The glass comes 3/4" smaller in both width and height than the size of the finished opening.

Click here for designer glass finishes See the bronze and grey options

Call (800) 426 3929 or Email for quotation on products and shipping.

 These watertight hinges are spring loaded, self leveling hinges. Not continuously closing. The hinges hold the door in the open position at 90 degrees (key for maintenace) and the spring acuates when approaching the closd posiion to hold the door closed against the polycarbonate bulb seal. The hinge strip mounts directly to a tiled jamb and has a bulb seal that seals to the glass on the hinge side to create the watertight seal. A similair continuos strip with bulb seal is used on the strike side..

* These glass doors must ship upright on a pallet via common carrier. If a liftgate is required that must be selected in the dropdown menu. They come packaged and shrink wrapped for quick release, so the door can be easily removed from the pallet to be offloaded by hand.